Eddie bauer baby gate installation instructions

The adjuster should go through the right side side of the belt opening. Latch the belt hooks to the lower anchors in your vehicle. Push on the base firmly and tighten the belt. Close the belt lock. Place the base of the infant seat onto the seat of the vehicle with the tall part of the base toward the rear of the vehicle.

Push down on the middle part of the lock to open plate A. Slide the seat belt through the opening on either side of the base so that the seat belt sits along the open portion of plate A.

Buckle the seat belt and tighten the seat belt. Pull on the seat belt firmly while closing plate A and the belt lock. Place the infant car seat directly onto the car seat, facing toward the rear 1. Slide the seat belt across the belt path, located where the back of the car seat meets the front, usually across the infant's middle.

If you are moving the car seat to another vehicle without the base, use the seat belt installation. With any installation, if the car seat can move more than 1 inch in any direction, you will need to tighten the car seat more. Infants should always be located in the back seat of a vehicle, facing toward the rear. In case of an accident, this is the safest place for an infant. When the high chair is secure, lift your child up under her arms and gently sit her in the chair so that she is centered.

The middle strap should be directly between her legs. Connect both buckles from the side straps to the connector on the crotch strap until they click into place. Give them a firm tug to ensure they are latched. Pull on the excess length of each strap to remove the slack.

There should be enough room between your child and the straps for you to stick a finger between. Grab the main tray from underneath and pull toward you. The tray will move upward and into position at the child's midsection. Press on the handle on the front of the tray to unlock it, allowing you to slide it backward or forward to give your child more room. You can also remove it by pulling forward. Push down on the tabs on either side of the top of the tray to remove the insert.

This allows you to take the insert to the kitchen for use as a tray for your baby's food. Place the insert back into the main tray by pressing downward until it locks into place.